HYDAC ENS 3000 - Manual (Page 7)

E
7
• Display of the lowest fluid level "n.MIN"
Continuously displays the lowest fluid level measured in the system since the
unit was last switched on or reset.
• Display of the actual temperature "TEMP"
• Display of the peak temperature" T.TOP"
Continuously displays the highest temperature measured in the system since
the unit was last switched on or reset.
• Display of the lowest temperature "T.MIN"
Continuously displays the lowest temperature measured in the system since
the unit was last switched on or reset.
• Display of the pre-set switching point "S.P. 1", "S.P. 2", "S.P. 3" or
"S.P. 4"
Continuously displays one of the switching points 1 to 4, depending on the
model
• Display off "oFF" Display is switched off
Either "n.TOP", "n.MIN", "TEMP", "T.TOP", "T.MIN", "S.P. 1", "S.P. 2",
"S.P. 3", "S.P. 4" or "oFF" appears briefly in the display following the
switch-on message, depending on the setting that has been made. The ; or <
key may be used to scroll through the above fluid levels and temperatures. If
neither of these keys is pressed within approx. 5 seconds, the value of the
parameter pre-set to appear in the display will be shown.
Notes:
• If the actual fluid level exceeds the upper limit of the unit's nominal range, it
can no longer be displayed and the display starts to flash. Either the peak fluid
level that has been measured or the peak fluid level plus the pre-set offset, is
then displayed.
• If the actual fluid level falls below the lower limit of the unit's nominal range, it
can no longer be displayed and the display will start to flash. Either "000" or
the pre-set offset is then displayed.
• If the display has been set to "display the actual fluid level" it is possible to
display first the peak fluid level by pressing the < key. Pressing the < key
again will then, in turn, display the lowest fluid level, the actual temperature,
the peak temperature, and the lowest temperature. The ; key can also be
used to scroll through the above list, but in reverse.