HYDAC ENS 3000 - Manual (Page 18)

E
18
9.2 ALTERING THE MAIN PROGRAMMING ENABLE
Switch off the supply voltage or disconnect the unit from the supply voltage.
Note:
If any settings have been changed, "ProG" will appear briefly in the display
when the display is switched over. The new setting is then saved in the unit.
Press both arrow keys
simultaneously and
hold them down.
Switch on the
supply voltage
(hold keys down for 6 s.)
Display
(release
arrow keys)
FrEE
= programming enabled
Loc
= programming disabled
Use the or keys to alter the settings
→
ž
6s
Fluid level indication
→
ž
3s
→
ž
2s
HYDAC
mode
?
?
HYDAC
mode
?
?