Restore rack defaults – ETC CEM3 v1.5.1 User Manual

Page 51

Common Tasks

Restore Rack Defaults

Restoring rack defaults is a fast way to completely reset all rack settings back to their

original state. This feature is only intended for users with touring or portable racks

where a complete reset is a common requirement.

Restoring defaults on an installed rack is not recommended unless you are expressly told

to do so by ETC Technical Services.

To restore the factory defaults to your CEM3:

Step 1:

Save a backup of the rack configuration (see

Step 2:

Press and hold [Setup].

Step 3:

Tap [Reset], found in the upper left corner of the CEM3 interface.

Step 4:

Continue holding [Setup] until the “Deep Clear” screen appears.

Step 5:

Select “Yes” to clear all rack settings and restore the factory defaults.

Select “No” to abort.

C A U T I O N :

Restoring rack defaults will erase all rack data. Do not perform this procedure

unless you absolutely intend to restore the rack back to its original factory settings.