ETC Sensor+ CE Rack (ESR+) CEM+ to CEM3 Retrofit User Manual
ETC Sensors
Table of contents
Document Outline
- Introduction
- Unpack and Organize
- The Retrofit
- Preparation
- Remove the Old
- Data Terminations
- Attach new power harness
- Connect Dimmer Output Cables to New Backplane
- Install the New Backplane
- Change out the AF Cards (if present)
- Change out the Beacon PCB
- Finishing Touches
- Repeat the above steps for the remainder of connected racks.
- Verify the Retrofit
- Configure the CEM3