Install into the ern rack enclosure, Unison, Ride thru option kit – ETC Unison Ridethru Option Kit User Manual
Page 2
E T C S e t u p G u i d e
Unison
®
Ride Thru Option Kit
Unison Ride Thru Option Kit Setup Guide
Page 2 of 3
Electronic Theatre Controls, Inc.
Install Into the ERn Rack Enclosure
Step 1:
Remove modules from the ERn rack for ride thru option board installation access.
•
For an ERn2, remove only the bottom option module from the rack enclosure.
•
For an ERn4 with two Paradigm ACPs, remove the bottom option module and the
rack power supply from the rack enclosure.
Step 2:
Align the ride through option board to the mounting studs in the right corner of the ERn
rack (see graphic above).
•
Notice the mounting holes on the option board. Two are open ended slots used to
set the board in place and the remaining two standard mounting holes are used to
secure the board in place.
•
Align the open ended slots to the studs located closest to the bottom of the rack.
Step 3:
Secure the board to the top two mounting studs with the screws provided.
N o t e :
One Unison ride thru option board powers only one Paradigm ACP, therefore an
ERn4 rack with two Paradigm ACPs installed requires two ride thru option kits.
2008