ETC Desire Series XTI v1.6.0 - Manual (Page 20)

15 Desire XTI Series v1.6.0 User Manual
Safety Cable
The safety cable (or other approved safety device) should be attached to the fixture housing
and wrapped around the hanging structure (pipe). An appropriate attachment loop is
provided on the protruding tab of the fixture housing. Take care to leave as little slack as
possible in the safety cable to avoid the cable catching the yoke of the fixture.
Focus Adjustment
The fixture can be tilted up and down to focus the light where it is needed. Upon powering
the fixture, all colors are automatically on so you can focus the fixture. This preset remains
active until it is changed with an RDM configuration tool or DMX/RDM lighting control
device.
Adjusting the Tilt
Step 1: Loosen the yoke locking bolt.
Step 2: With the fixture turned on, tilt it to the desired angle.
Step 3: Tighten the yoke locking bolt.
Adjusting the Pan
The pan is adjusted at the hanging clamp or the mounting base. Consult the clamp
manufacturer’s documentation for instructions on loosening and rotating the yoke at the
clamp or refer to the appropriate installation instructions.
W A R N I N G : The safety cable (or other approved safety device) must be securely
attached to the safety cable loop before loosening the clamp.
Safety
cable
loop