Installation, Installation on a pipe, N o t e – ETC Desire Series XTI v1.6.0 User Manual
Page 19
1
Installation and DMX Profiles
14
Installation
The D40/D60 XTI fixtures can be mounted four ways.
•
On a pipe with a C-clamp
•
On a permanent base
•
On a pole
•
On a wall
Install on pipe or a suitable, rigid, permanent base with secured bolts. This can include
poured concrete pads, factory-supplied pole-top and wall-mount brackets, and other
attachments which meet the published weight and wind-load requirements for the fixture.
Detailed installation information is packaged with the fixture. Refer to D40/D60 XTI
Installation Instructions.
Installation on a Pipe
The D40/D60 XTI fixtures can be hung from a pipe using a C-clamp. The C-clamp attaches
the fixture to the mounting pipe and allows you to adjust the position of the fixture once it is
mounted.
Step 1:
Tightly fasten the C-clamp to the yoke with the provided yoke bolt and lock
washer.
Step 2:
Place the C-clamp on mounting pipe, then tighten the pipe bolt to secure it.
Step 3:
Loosen the C-clamp pan screw and rotate the yoke to the desired position.
Step 4:
Tighten the pan screw to lock the fixture.
Model
Weight
a
a) Does not include mounting hardware.
Shipping Weight
Wind Rating
Lbs.
Kg.
Lbs.
Kg.
D40XTI
15
6.8
18
8.2
.72 EPA
D60XTI
23
10.43
24.7
11.2
.95 EPA
N o t e :
The EPA number is obtained by estimating Cd(Wind Drag Coefficient) and
multiplying it with the projected area of the object. Wind Drag Coefficients were
obtained from AASHTO Sixth Edition 2013.
W A R N I N G :
Do not use this fixture with a damaged power lead. If the power lead (cord
set) is damaged, it must be replaced. Failure to follow this warning can
result in serious injury or death.
W A R N I N G :
All third-party mounting hardware should be corrosion-resistant and
designed for use where installed.
C A U T I O N :
Tighten the C-clamp pipe bolt to 15-20 ft./lbs. (approximately finger tight plus up
to one-quarter turn). Do not exceed 25 ft./lbs. Do not use excessive force.
Tighten the yoke pivot bolt to 5-10 ft./lbs. (approximately finger tight plus up to one-
eighth turn). Do not exceed 15 ft./lbs. Do not use excessive force.