Enerpac ATM-4 - Manual (Page 2)

2
1.0 RECEIVING INSTRUCTIONS
Visually inspect all components for shipping damage.
Shipping damage is not covered by warranty. If
shipping damage is found notify carrier at once. The
carrier is responsible for all repair and replacement
costs resulting from damage in shipment.
SAFETY FIRST
Read all instructions, warnings and cautions carefully.
Follow all safety precautions to avoid personal
injury or property damage during system operation.
Enerpac cannot be responsible for damage or
injury resulting from unsafe product use, lack of
maintenance or incorrect product and/or system
operation. Contact Enerpac when in doubt as to the
safety precautions and applications.
A CAUTION is used to indicate correct operating or
maintenance procedures and practices to prevent
damage to, or destruction of equipment or other
property
A WARNING indicates a potential danger that
requires correct procedures or practices to avoid
personal injury.
2.0 SAFETY ISSUES
Failure to comply with the
following cautions and warnings
could cause equipment damage
and personal injury.
IMPORTANT: Minimum age of the
operator must be 18 years. The operator
must have read and understood all
instructions, safety issues, cautions and warnings
before starting to operate the Enerpac equipment.
The operator is responsible for this activity towards
other persons.
CAUTION: Make sure that all system
components are protected from external
sources of damage, such as excessive
heat, flame, moving machine parts, sharp edges and
corrosive chemicals.
WARNING: Immediately replace worn or
damaged parts with genuine Enerpac
parts. Enerpac parts are designed to fit
properly and withstand rated loads.
WARNING: Always wear safety glasses.
The operator must take precaution
against injury due to failure of the tool or
workpiece
We recommend the use of special
loosening liquids or sprays. Enerpac
hydraulic torque wrenches offer both
square and hexagon drive units to loosen or tighten
bolts and nuts. Enerpac offers nut splitters in case a
nut can not be removed.
3.0 PRODUCT DESCRIPTION
The ATM-4 Alignment Tool is intended for use in
typical maintenance and installation procedures. It
allows the realignment of misaligned flanges within
a 4 ton [40 kN] physical capacity. It may be used
to assist in the replacement of ring and other type
joints.
The use of these instructions will promote the safe
use and maximum service life of the tool. All sections
of this instruction sheet should be read prior to using
the tool.
3.1 Applications
The ATM-4 Alignment Tool can be used for:
Flange change outs, repair of pipe lines, replacing
bolts, gaskets and seals and for aligning parts for
fabricating.
3.2 Major Features and Components
See Fig. 1. for an overview of ATM-4 major features
and components.
LIFT HOOK
TORQUE WRENCH
AND 22 mm SOCKET
DROP LEG
Fig. 1
SCREW BOLT
WING LOCK PIN
DROP
LEG
KNOB
SWIVEL
3.3 Capacity Information
Maximum Load
Wing Fully Retracted: Wing Fully Extended:
3.0 T [30 kN] from 50
ft-lbs [68 Nm] of torque.
4.0 T [40 kN] from 50
ft-lbs [68 Nm] of torque.