COATS IBS 2000 Wheel Balancer - Manual (Page 20)

14 • COATS IBS 2000 Interactive Balancing System
Direct Drive
Maintenance
The balancer requires only minor maintenance to
keep the unit operating properly.
1. Keep the display clean and clear. Use a vaporizing
cleaner only. Do not use cleaners or solvents which
leave oily or filmy residues behind.
2. Keep the adapters, cones, faceplate, threaded
arbor, pressure cup, and hub nut clean. Grease and
dirt buildup will cause premature wear and inaccurate
balancing. Clean these items at least once a day with
a vaporizing solvent.
3. Clean the weight tray, accessory posts, pegs, and
storage shelves with a vaporizing solvent. Weights
stored in a dirty tray will pick up grease and dirt which
may alter their weight or keep them from securely
attaching to the wheel.
Do not hose down or bucket wash the bal-
ancer. Extensive damage to the balancer
will result. Sensitive electronic compo-
nents, wiring harnesses, and other devices
housed in the balancer are not intended to
be exposed to water.
Exposing the balancer to water, either by
hose pipe or bucket, or by exposure to rain
or snow, may cause risk of shock or elec-
trocution to operator or bystanders. Place,
store, and operate the balancer only in a
dry, sheltered location.
4. Keep the area around the balancer clear. Remove
any tools or other items that are leaning against the
balancer. Keep the area under the balancer clear as
well. Remove any items that may cause the balance to
not sit level.
5. Use only COATS accessories. Accessories from
other manufacturers may not fit or function properly,
and may damage the balancer.
Total Accuracy
Verification
The IBS 2000 includes software that will prompt the
user to check the accuracy of his machine periodically.
The procedure is accomplished as follows:
1. Go to the main menu and select Setup. Press
enter.
2. Arrow through the selections to TAV. Press enter.
3. The menu will now display several "preset" selec-
tions to choose from, or the customer may wish to
SPECIFY (choosing your own). The default is 5000
cycles. Press enter.
4. If SPECIFY (choose your own) is selected, the
menu will prompt to enter the number of cycles
desired. Enter the number and press enter.
5. After the balancer reaches the selected number
of cycles the customer will receive THE MESSAGE.
Do you wish to perform T.A.V.? YES or NO.
6. If NO is is selected, the balancer will return to
normal balancing mode.
7. If YES is selected, the balancer will switch to cal-
ibration.
8. Follow the instructions on the display and per-
form normal calibration.
WARNING
CAUTION