COATS IBS 2000 Wheel Balancer - Manual (Page 14)

8 • COATS IBS 2000 Interactive Balancing System
Direct Drive
Selecting Balancing
Options
Using the Menu
Use the menu on the interactive display to access
setup screens, match mount procedures, calibration,
and diagnostics. Open the menu by pressing the
MENU button on the display. The five buttons below
the display will be labeled with their function for each
screen you access.
These buttons typically are (from left to right):
ENTER, PREVIOUS, EXIT, up arrow, and down arrow.
Pressing ENTER toggles your current selection on or
off (or selects the option), PREVIOUS returns you to
the previous screen, and EXIT returns you to the top
of the menu. Use the scroll up and scroll down arrows
to scroll through options and selections. Up and/or
down arrows will be displayed at the top or bottom of
the screen if there is more information above or below
what's shown.
Match Mount - (see pg.11)
Calibration
• Calibrate Balancer - (see pg.14)
• Calibrate Arm - (see pg.15)
Set Up
Round Off - The default weight measurement on the
IBS 2000 is 0.25-ounce. The balancer can be set to a
non-Round Off mode that displays weights in 0.01-
ounce increments. Select SETUP from the menu,
select ROUND OFF from the list, and press ENTER to
turn this option on or off. Status of this option is
shown in the top of the display as well.
Ounces or Grams - Set the balancer to measure and
display weight amounts in grams. Select SETUP from
the menu, select OUNCE or GRAM from the list, and
use ENTER to select the weight type. Status of this
option is shown in the top of the display as well.
Hood Start - Sets the balancer to start spinning as
soon as the hood is fully lowered. Select SETUP from
the menu, select HOOD START from the list, and use
ENTER to turn this option on or off. Status of this
option is shown in the top of the display as well.
RV Mode - For wheels that do not require balancing
in increments of less than 0.5-ounce. Calculates bal-
ancing weights in 0.5 increments only. Select SETUP
from the menu, select RV MODE from the list, and
use ENTER to turn this option on or off.
Stop-on-Top - The IBS 2000 will automatically brake
the wheel to a stop at the end of a spin cycle. The bal-
ancer will brake once to slow the wheel and a second
time to stop the wheel with the outer weight position
at or near the top. If no weight is required on the outer
plane, it will brake the wheel to stop based on the
inner weight position. Select SETUP from the menu,
select STOP ON TOP from the list, and use ENTER to
turn this option on or off.
Total Accuracy Verification (TAV) - (see pg.14)
LED Intensity - The LED brightness may be adjusted
to make them easier to read in all lighting environ-
ments, bright as well as dark, and those in between.
The last item on the MENU list is LED INTENSITY.
Select this item from the menu and follow the instruc-
tions on the display to brighten or dim the LEDs.
Diagnostics - (see pg.17)
Operator A/B - Two operators utilize the balancer
without clearing or changing each others data. This is
handy when one operator is running the Match Mount
procedure and another operator needs the balancer.
For example, if operator A is at a point in the Match
Mount procedure where the wheel is removed from
the balancer, operator B can access the machine by
switching to the other operator memory. When B's
balance is complete, he can toggle the machine back
to A's memory. All of operators A's data is still pres-
ent, and the Match Mount procedure can be contin-
ued without having to start over. Press the
OPERATOR key to toggle between the two operator
memories.