COATS IBS 2000 Wheel Balancer - Manual (Page 18)

Match Mount Instructions
1. Select Match Mount from the LCD menu.
• Hood start is turned off automatically
• Non-round off is turned on automatically
• MM will now be displayed in the upper left corner of the LCD
screen.
• Enter wheel parameters
2. Lower the hood and press START.
• MATCH MOUNT 1 will now be displayed in the upper left
corner of the LCD screen.
3. Raise the hood and rotate the wheel until the valve stem is
at top-dead-center.
4. Press 1 on the touch panel.
• MATCH MOUNT 2 will now be displayed in the upper left
corner of the LCD screen.
5. Press the MORE softkey to read the second page of
instructions on the LCD screen.
6. Remove the wheel from the balancer. Completely deflate
the tire by removing the valve core. After all the air pressure is
exhausted, follow the tire changer manufacturer's instruction for
loosening the tire beads.
A second operator can use the 2000 balancer while the Match
Mount operator performs steps 6, 7, and 8. All data for the
Match Mount procedure will be kept in the Match Mount oper-
ator's memory (A or B).
7. Lubricate both tire beads and wheel to aid in rotating the
tire and bead sealing and seating. Always use the tire manufac-
turers approved rubber lubricant.
8. Rotate the tire 180° on the wheel.
9. Replace the valve core and inflate the tire. Follow the tire
changer manufacturers instructions for inflation.
10. Remount the wheel on the balancer.
Remember: If another operator memory (A or B) has been
selected, reselect the memory being used for the Match Mount
procedure. The balancer will return to the point in the procedure
where the other memory was selected.
11. Press the 2 on the touch panel
• MATCH MOUNT 3 will be displayed in the upper left corner
of the LCD screen.
12. Lower the hood and press START.
13. Wait for the wheel to stop. Raise the hood and rotate the
wheel until the valve stem is at top dead center.
Direct Drive
12 • COATS IBS 2000 Interactive Balancing System
Figure 10 - Rotate the wheel
Figure 11 - Rotate Tire on Wheel
Tire/wheel
assembly rotated
until valve stem
is at top-dead-
center.
Tire rotated 180
degrees on the
wheel.
Figure 12 - Rotate the Wheel
Tire/wheel
assembly rotated
until valve stem
is at top-dead-
center