COATS IBS 2000 Wheel Balancer - Manual (Page 19)

14. Press 4 on the touch panel.
• MATCH MOUNT 4 will be displayed in the upper left corner
of the LCD screen.
15. Rotate the wheel until the weight position LEDs flash.
While the LEDs are flashing, mark the tire at top dead center
and press CONTINUE.
16. Press the MORE softkey to read the second page of
instructions on the LCD screen.
The weight breakdown will now be displayed on the LCD
screen. The weight imbalance due to the wheel (rim) will be dis-
played above the weight imbalance for the tire. The percent of
the total weight is also given to aid in determining, which has
the greater effect on the imbalance, the tire and/or wheel.
Use these weights to determine the suitability of the rim or
tire. High imbalance may indicate a rim that is out of round or
misformed, or a tire with a bubble or other problem. If the imbal-
ance is excessive, it may be prudent to replace the rim, the tire,
or both. If either is replaced, do not continue with this proce-
dure. Balance the new tire and rim and evaluate the readings for
Match Mount suitability.
17. Remove the wheel from the balancer. Completely deflate
the tire by removing the valve core. After all the air pressure is
exhausted, follow the tire changer manufacturer instructions for
loosening the tire beads.
A second operator can use the 2000 balancer while the Match
Mount operator performs steps 18, 19, and 20. All data for the
Match Mount procedure will be kept in the Match Mount oper-
ator's memory (A or B).
18. Lubricate both tire beads and wheel to aid in rotating the
tire and bead sealing and seating. Always use the tire manufac-
turer's approved rubber lubricant.
19. Rotate the tire until the mark is aligned with the valve
stem.
20. Replace the valve core and inflate the tire. Follow the tire
changer manufacturer instructions for inflation.
Remember: If another operator memory (A or B) has been
selected, reselect the memory being used for the Match Mount
procedure. The balancer will return to the point in the procedure
where the other memory was selected.
21. Remount the wheel on the balancer.
22. Press CONTINUE.
23. The balancer will return to standard balancing mode.
Direct Drive
COATS IBS 2000 Interactive Balancing System • 13
Figure 13 - Rotate the wheel
Tire/wheel
assembly rotated
until weight posi-
tion lights
flashed. Tire
marked at top-
dead-center.
Figure 14 - Rotate Tire on Wheel
Figure 15 - Match Mount Completed
Tire rotated so
mark is aligned
with valve stem.
Wheel ready for
balancing