Problems & possible solutions, Problems & possible solutions -7 – chiliGREEN X8100 User Manual
Page 193
Troubleshooting
Problems & Possible Solutions 8 - 7
8
Problems & Possible Solutions
Problem
Possible Cause - Solution
You turned the power on
but it doesn’t work.
Battery missing / incorrectly installed. Check the battery bay, make sure the battery is present
and seated properly (the design of the battery only allows it to go in one way). Make sure there’s
nothing interfering with the battery contacts.
The Battery LED power
indicator ,
is
blinking
orange.
Low Battery. Plug in the AC power source. If the computer doesn’t start up immediately, turn it off
then on again.
You are losing battery
power too quickly.
The system is using too much power. If your OS has a Power Options scheme (see
) check its settings. You may also be using an ExpressCard device/USB
device/external device that is drawing a lot of power.
You are attempting to run an SLI configuration on battery power. Due to the high power and
system demands created by enabling SLI Configuration, you should not enable SLI
configuration if your computer is powered by battery only.
Actual battery operating
time is shorter than
expected.
The battery has not been fully discharged before being recharged. Make sure the battery is fully
discharged and recharge it completely before reusing (see
“Battery Information” on page 3 -
).
Check the settings of any active power plan (see
A peripheral device/USB device is consuming a lot of power. Turn off/remove the unused device
to save power.