CCTV Camera Pros iDVR-PRO A Series DVRs - Manual (Page 34)

System Setting
34 |
System Setting
\ \ Motion Sensor
Set the motion sensor of the camera so that it can detect a motion event.
1. From - , select
.
2. Use the [ ▲▼◀▶ /ENTER] buttons on the remote
control or use the mouse to specify the use of each
option item.
i
ACTIVATION : turn on or off the motion sensor.
i
MARK : Set to to display the motion
detection indicator on each video tile where
applicable.
i
SENSITIVITY : Set the sensitivity level of the
motion sensor to either Daytime or Nighttime.
i
EDIT AREA : Specify the motion detection area.
3. To apply the change, click in the bottom of the screen.
4. When done, press the [EXIT] button on the remote control or click in the lower screen. The confirmation
message appears and you will return to the previous menu.
J The motion detection sensitivity may differ depending on the characteristics of the connected camera or the installation environment.
Motion Area Setup
From the motion setup window, click in the right corner to display the area setup screen.
Setting the motion area may differ depending on the camera model. Below is a typical setting of the motion area.
1. Click to move to the motion area
setup screen.
2. If using the remote control, press the [ENTER] button
to mark the current position.
3. Use the arrow buttons to move to a desired block and
press [ENTER]. The area setup will begin.
Then, use the arrow buttons to specify the area.
Alternatively, you can use the drag-and-drop method to
specify or release the area as using mouse.
4. If you select the specified area again, it will be
released.