Atop Technology SE5404D User manual User Manual

Page 49

User manual Version 1.3

4-Port DIN-Rail Serial Device Server SE5404D

- 48 -

Figure 3.39 System Log Setting WebUI

Enable Log Event to Flash: This would write log events to the local flash.

Log Level: 3 (Currently we only allow this level)

Enable Syslog Server: Enabling this option would allow you to send Syslog events to a remote Syslog server.

Syslog Server IP: Please specify the remote Syslog Serve IP.

Syslog Server Service Port: Please specify the remote Syslog Serve Port.

Figure 3.40 COM Log Setting WebUI

Log Data Contents: If enabled, the COM logging function will log data content. If disabled, COM logging function

will only log data length to reduce system load.

Note that the local flash storage has a very

limited space. If the reserved space is full new logs will replace the old logs. We strongly
recommend sending COM logs to a remote Syslog server.

Data Log Types: Hex or ASCII

COM 1~4 : Choose which port to log.

Enable Syslog Server: Enabling this option would allow you to send COM logs to a remote Syslog server. You can

send COM logs to the same Syslog server used previously.