2 tcp client for link mode – Atop Technology SE5404D User manual User Manual
Page 39

User manual Version 1.3
4-Port DIN-Rail Serial Device Server SE5404D
Copyright © 2011 Atop Technologies, Inc.
All rights reserved. Designed in Taiwan.
- 38 -
Figure 3.29 TCP Server in Link mode
Note: Enable Virtual COM mode if the remote site PC’s “Serial to IP” tool installed
3.4.2 TCP Client for Link Mode
One may enter destination IP & port (default: 4660) to establish connection of counter-pair (remote) host
(For example, another serial server, or PC for data-collection). Serial Server can support two destination
hosts simultaneously.
If you check “Apply to all serial ports”, it will configure all of the serial ports.