Nstallation, Rocedures, 2 installation procedures – Atop Technology SE5404D User manual User Manual

Page 15: Attention

User manual Version 1.3

4-Port DIN-Rail Serial Device Server SE5404D

- 14 -

Blinking

AP firmware is running normally

2.2 Installation Procedures

Step 1: Connect SE5404D to power source

Step 2: Connect SE5404D to the Ethernet network. Use a standard straight-through or cross-over Ethernet

cable Always make sure the PC is on the same network subnet as SE5404D.

Step 3

: Connect SE5404D’s serial port to a serial device.

Step 4: Mount SE5404D to a Din Rail.

Attention

Disconnect the device from power source completely before installing and wiring
the server.

Do not exceed the maximum allowable current of the power cord and common
wire. Applying the wire over its specification would cause the wire to overheat and
cause serious damage to the connected and neighboring equipment.

The casing could become too hot to touch when operating in harsh environments.
Please handle with care.

RESTRICTED ACCESS AREA: The equipment should only be installed in a

Restricted Access Area.