Atop Technology SE5001A User manual User Manual
Page 32
User Manual Version 1.0
SE5001A Serial Device Server
30
Enable SNMP and Alert Events by
checking “Enable” (Figure 3.20). Fill in SNMP information in the fields under the
SNMP header. Enable different Alert Events to send these events to a SNMP Trap Server.
Cold/Warm Start: Triggers when the device is rebooted from the application level or physical level.
Link Down: Triggers when the TCP connection of the designated COM port is closed
Link Up: Triggers when the TCP connection of the designated COM port is established
Authentication Failure: Triggers when the username/password entered in the Telnet console or the WebUI is
incorrect.
Figure 3.20 SNMP Setup
After all the settings are entered, please click on the
“Save Configuration” button to save the changes. Note that
the settings would become active only after SE5001A is restarted.