Atop Technology SE5001A User manual - Manual (Page 21)

User Manual Version 1.0
SE5001A Serial Device Server
19
3.2.5. Configure SE5001A as TCP server
Figure 3.7 Link Mode: TCP Server Setup
 Type 1 (Link Mode) from “Input choice and enter (1~4):” of COM1
 Type 1 (TCP Server) in the “Input choice(1~5) and enter：”
 Input local port in the “Please input local port：”
To Enable IP filter：
 Input y in the “Do one want to enable IP filter(y/n)?” to enable IP Filter. Otherwise input n.
 Input source IP in the “Please input Filter_IP ：”
 Double click “Enter” key
 Input idle time in “Please input idle time to send TCP alive packet(x*10sec)：”(ex. Input 2 to change the
sending TCP keep alive packet period to 20 sec)
Note:
1. IP filtering function is disabled if setting FILTER_IP to “0.0.0.0”.
2. IP filter is disabled by default
3. If IP filter is enabled, only source IP assigned can connect to SE5001A ’s COM.
4. If the multi-connection firmware is installed, SE5001A will prompt for “Multi_Port”, meaning multiple
connection