Anchor EVENT SERIES - PROFILE SIZE: 20M - 220X100X4 - 3M UPRIGHTS - Manual (Page 45)

Spanning the world.
BT 2000 240/300 570/627
44
7 Service notes
7.1 Construction of the tent
7.1.1 The restretching of the wind bracings, treaded bolt connections and
roof racings is requisite:
- every 3 months (stand-by time)
- after hot periods
- after a strong gale
7.1.2 Pay attention to the earth-anchors, that is deep seated in a solid
position.
7.1.3 Check for deformation or damage.
7.1.4 If there are any damaged parts, then change them immediately with
new original spare parts.
7.2 Bedding and transport
To avoid damage to the aluminium profile you have to bed and to transport
all the aluminium profiles on a smooth area (e.g. RÖDER transport units) and
you have to pay attention to the profile, that stand out on the smaller profile
side.
7.3 Routine visual inspection
Periodically carry out a visual inspection after every use (e.g. after every event
day):
The inter- and eave purlins have to be hung up according to the rules.
The bolt- and pin connections have to be inspected.
Dirty covers have to be cleaned (the washing can take place in our own
RÖDER laundry).