Anchor EVENT SERIES - PROFILE SIZE: 20M - 220X100X4 - 3M UPRIGHTS - Manual (Page 35)

Spanning the world.
BT 2000 240/300 570/627
34
5 Mounting of tent’s covers
Before starting the mounting of the tent’s covers, all earth-anchors have to
be beaten in and the wind bracings tightened (compare point 4).
Use the leading-in conductor for covers. It makes mounting easier and helps
to avoid damages to the covers.
Do not try to pull in the cover with force. If there is any heavy resistance, pull
back another time and try again.
Prepared assembling auxiliares:
Construction tools:
Building components:
3x traction cables with carabine All the roof covers
2x leading-in conductor for covers
mounting rod
5.1 Pulling up the roof cover
5.1.1 Set in right position the leading-in conductor to each of the open
ends in both of the beams to a tent’s longest side (pic. 19).
5.1.2 Throw a traction wire from left to right over the ridge of the first
brace field.
5.1.3 Pull with this wire two more traction wires over the ridge.
5.1.4 Place in the right position respective roof covers. (Buckles have to
show on the outside and right) (pic. 19).
5.1.5 Hang up both of the traction wire with the carabine hooks to both of
the outer
traction eyes of the roof cover. Hang up the 3. traction wire to a
traction eye
(pull back rope) (pic. 19).