Anchor EVENT SERIES - PROFILE SIZE: 20M - 220X100X4 - 3M UPRIGHTS - Manual (Page 44)

Spanning the world.
BT 2000 240/300 570/627
43
6 Dismantling
For the dismantling of the tent you have to follow the instructions in reverse
to the construction.
The principle of dismantling:
All the covers of the tent ought to be dry before you start folding.
After dismantling you have to mark, sort and load all the building
components immediately.
The using of the peg puller, which is provided as an accessory part, makes
the removing of the earth anchors easier.
6.1 Dismantle the ground rails.
6.2 Undo, dismantle and lay on clean ground the sides- and the gable
walls and fold them together, resp. roll in pairs every accompanying
eye- and loop side.
6.3 Undo, dismantle and lay on a clean ground the gable covers and fold
them together, resp. roll in pairs every accompanying eye- and loop
side.
6.4 Unhook the roof cover bracing, resp. remove and dismantle it.
6.5 Remove from each other the buckle straps, resp. bur band of the roof
covers.
6.6 Remove the roof cover, place it on clean ground and fold it together,
resp. roll it.
6.7 Dismantle the gable supports and gable eave rails of the first gable.
6.8 Mount the setting rods to the first corner legs of one gable side and
fix the pin tightly.
6.9 Loosen the wind bracing to the first field.
6.10 Dismantle the wind bracings of the first field.
6.11 Dismantle all purlins of the first field.
6.12 4 people are fixing tightly the first bay.
6.13 Lay down the first bay carefully.
6.14 Dismantle the beams, legs and middle ridge connectors for all the
bays.
6.15 Repeat the points 6.7 and 6.14 for all the bays.
6.16 Pull
the anchors.