AirLive WIAS-3200N v2 - Manual (Page 91)

5 Configure Wireless Connection
85 AirLive WIAS-3200N v2 User’s Manual
802.11g Protection: Click Enable button to activate 802.11g Protection Mode, and
Disable to inactivate 802.11g Protection Mode.
Change these settings as described here and click Save button to save your changes.
Click Reboot button to activate your changes. The items in this page are for AP's RF
general settings and will be applied to all VAPs and WDS Link.
5.3 Virtual AP Setup
The WIAS-3200N v2 support broadcasting multiple SSIDs, allowing the creation of Virtual
Access Points, partitioning a single physical access point into 8 logical access points, each
of which can have a different set of security, VLAN Tag(ID) and network settings. If wireless
client connect to wire area network with VLAN Tag (ID), the administrator can use dump
switch or VLAN switch on wired area network, below picture shows multiple SSIDs with
different VLAN settings use dump switch connect to wired area. It also shows multiple
SSIDs with different VLAN settings use VLAN switch connect to wired area.
Multiple SSIDs with different VLAN settings use dump switch connect to wired area.
Multiple SSIDs with different VLAN settings use VLAN switch connect to wire area.