Appendix h. using stbconnector for power input, Appendix h. using stb connector for power input – AirLive WIAS-3200N v2 User Manual

Page 170

AirLive WIAS-3200N v2 User’s Manual

164

16.

Appendix H. Using STB

connector for power input

For any DC power input, you may use STB as power convertor.

Step 1. Loosen the screw on top of the STB-male connector

Step 2. Plug in the ground pin of your DC power into the right position hole of STB-male

connector (Shown as Fig1.)

Step 3. Plug in the DC power into the left position hole of STB-male connector (Shown as

Fig1.)

Step 4. Tighten up the screw on top of the STB-male connector, makes sure the DC cable

has been fixed properly.

Step 5. Insert the STB-female connector to the rear side of device (Shown as Fig2.)

*Note: Check the DC power apply to STB connector fist, makes sure the DC power is

12VDC

Fig1.

Fig2.