2N Fixed line replacement with 2N SmartGate - Manual v1.1.2 - Manual (Page 57)

Voice function 4.1
57
Incoming call on FXO interface
1. 2N® SmartGate detects a ringing signal and immediately interconnects it to
FXS interface – the phone starts to ring.
2. The CLIP transmitting must provide connected PBX.
3. If you hook off the phone the call is established.
Automatic Call ("BabyCall")
If the BabyCall function is enabled on FXS interface, a pre-programmed timeout
is counted down after off-hook. If you don‟t start dialing within this timeout, 2N®
SmartGate signals dialing end and starts to establish a call to the pre-programmed
number using GSM network automatically – from now 2N® SmartGate behaves as
if a standard outgoing call to GSM had been established. Any dialing during the
BabyCall timeout cancels this function and a standard outgoing call can be made.
ME- Mobility Extension
ME function takes place during ringing on FXS interface if 2N® SmartGate is
programmed as DialThru gateway.
Fill in telephone number for ME function and number of rings to ME function start
on FXO routing table sheet.
1. 2N® SmartGate detects a ringing signal and immediately interconnects it to
FXS interface – the phone starts to ring.
2. If there is no call connection before the pre-programmed number of rings, 2N®
SmartGate simultaneously establishes call to GSM network. Some timeout take
place between GSM call establishing start and ringing of mobile phone.
3. As long as 2N® SmartGate detects ringing on FXO interface, connected analog
and GSM phones ring.
4. You can receive the call on analog line as well as on your mobile phone.
5. During call received on mobile phone you can send FLASH to PBX, for special
PBX functions, by preprogrammed DTMF code.
If you want repeatedly temporarily disable and afterwards enable the ME
function, fill in Password for ME activation/disabling. If password is filled in:
1. Hook off the phone.
2. For temporarily disabling the function dial the password and confirm by
For activation the function dial the password and confirm by .
3. Hang up.
Tariff pulses 16 or 12 kHz
2N® SmartGate has tariff pulse transmitter on FXS interface. You can use tariff
pulses for outgoing call pricing. 2N® SmartGate offer pseudotariff only – tariff
metering doesn‟t correspond to real price of call, tariff pulses are transmitted
according to programmed parameters and call duration. You must program specific
parameters in FXS routing table to set tariff metering for different prefixes of dialed