2N Fixed line replacement with 2N SmartGate - Manual v1.1.2 - Manual (Page 52)

Table of Parameters 3.2
52
Telephone number for service SMS Function No.: 714
Telephone number for service SMS. The number is common for GGMC SMS and
"LOW CREDIT" SMS on prepaid SIM cards.
Setting options: 0-16 characters (0-9,*,#,+)
Default setting: blank
Service Parameters
Hardware version Function No.: -
2N® SmartGate hardware version - for information only (cannot be modified).
Must be used for communication with the manufacturer.
Firmware version Function No.: -
2N® SmartGate firmware version - 2N® SmartGate central processor program
version. The manufacturer can issue upgrades to extend functions. To load new
firmware into 2N® SmartGate use the Upgrade function. Keep communicating
with the manufacturer.
Serial number Function No.: -
2N® SmartGate serial number - for information only (cannot be changed). Must
be used for communication with the manufacturer.
Blocked by operator Function No.: -
Refer to GSM & SIM Parameters.
COM enable Function No.:960
With this parameter you can enable/disable the serial interface function. You can
disable communication in the operating mode, maintaining the special
programming mode after power up.
Setting options: YES(1)/NO(0)
Default setting: YES
Time limit for data connections [min] Function No.: -
After time elapsing is data/fax connection terminated immediately without
warning. The "0" setting means that the function is disabled.
Setting options: 0-255 min
Setting step: 1 min
Default setting: 0
Time period for GGMC SMS [h] Function No.:970
Time interval for GGMC SMS sending. GGMC = GSM Gateway Monitoring Centre.
The "0" setting means that the function is disabled.
Setting options: 0-255 h
Step: 1 h
Default setting: 0