2N Fixed line replacement with 2N SmartGate - Manual v1.1.2 - Manual (Page 41)

Table of Parameters 3.2
41
Remember to complete the "Other prefixes" line for a number whose prefix
is not found in the table.
An example in the figure shows how to bar all international calls with the exception
of calls to Slovakia. Calls to Slovakia are routed through FXO interface and the call
is established immediately after 14 digits are dialed. All other calls are enabled and
they are routed to GSM network. Their tariff is one impulse every 30 second and
you can accelerate connection establishing by dialing of a # after the dialed
number. Maximal length of the call is 10 minutes.
Operator for Integra Function No.: 405
In some GSM networks you can add to dialed number # character and PBX
subscriber number. Subscriber number is displayed on other side together with
CLI. This parameter take place when dialed number doesn't contain # character.
Common parameter for both FXO and FXS port.
Setting options: 0-8 characters (0-9)
Default setting: blank
Caution!
 Configuration using phone line programming (DTMF) is applicable for line
„Other prefixes‟ only.
Prefix Function No.: -
Dialed number prefix identifying the call type. "Other numbers" line is used for
calls with prefixes that are not included in the table.
Setting options: 0-16 characters (0-9,*,#)
Default setting: blank
Call enable Function No.: 391
This parameter allows/bars calls with corresponding prefixes.
Setting options: YES(1)/NO(0)
Default setting: YES
Route to Function No.: 392
The Remove parameter is used for automatic call routing. A defined count of
digits (prefix) is removed from the number beginning.
Setting options: 0-20
Setting step: 1
Default setting: 0
Number length Function No.: 393
The parameter defines the expected length of dialed number. It enables to start
dialing into GSM or FXO interface immediately after the last digit is dialed. If the
telephone number to be dialed is shorter, a timeout is respected. The "0" setting
means that the function is disabled.
Setting options: 0, 3-15
Setting step: 1
Default setting: 0