2N Fixed line replacement with 2N SmartGate - Manual v1.1.2 - Manual (Page 39)

Table of Parameters 3.2
39
„BabyCall“ – Automatic call
BabyCall number Function No.: 280
If 2N® SmartGate is programmed as FXO gateway, parameter defines a number
to be dialed for the automatic call function. If this item is blank, the function is
disabled. If only character „#‟ is included, after BabyCall timeout elapsed the
interfaces FXO and FXS are connected and dialing to PSTN over FXO interface is
possible.
Setting options: 0-20 characters (0-9,*,#,+)
Default setting: blank
BabyCall timeout [s] Function No.: 281
If 2N® SmartGate is programmed as FXO gateway, parameter defines time
between line Off-Hook and automatic call beginning (if enabled). During this
timeout 2N® SmartGate waits for dialing that cancels the automatic call. You
can make standard call if the BabyCall function is enabled.
Setting options: 0-255 s
Setting step: 1 s
Default setting: 0 s
Mobility extension FLASH
Mobility Extension FLASH DTMF code Function No.: 240
Fill in DTMF code to enable GSM FLASH function. If 2N® SmartGate receive
DTMF dialing corresponding to filled code during GSM - FXO call, it generates
FLASH to FXO interface.
Setting options: 0-4 characters (0-9,*,#)
Default setting: blank
FLASH length [ms] Function No.: 241
Time of current loop interruption (line On-Hook) during FLASH.
Setting options: 100-1500 ms
Step: 100 ms
Default setting: 100 ms
FXS routing table parameters
All parameters related to the dialed number and call routing are arranged in three
routing tables. Each table pertains to one interface: FXS, FXO and GSM.
According to the prefix of dialed number on FXS interface you can:
 Bar the number to be dialed - the calling subscriber tone;
 Route the call to GSM network, or to PBX through the FXO interface;