2N Fixed line replacement with 2N SmartGate - Manual v1.1.2 - Manual (Page 34)

Table of Parameters 3.2
34
Setting step: 1
Default setting: 3 = medium volume level
Reception volume Function No.: 191
Volume setting for GSM reception with a 4 dB step.
Setting options: 1-5
Setting step: 1
Default setting: 3 = medium volume level
Ringing signal settings
Ringing signal – frequency [Hz] Function No.: 140
Ringing signal frequency setting.
Setting options: 25 / 50 Hz-2N® SmartGate rings with 50 or 25 Hz on
FXS interface
Default setting: 50 Hz
Ringing signal - cadence Function No.: 141
Ringing signal cadency setting.
Setting options: 1000/4000 ms (0) - 1 s ring, 4 s pause
400/200/400/2000 ms (1)- 400ms ring, 200ms pause,
400ms ring, 2s pause
1500/3500 ms (2) - 1,5 s ring, 3,5 s pause
2000/4000 ms (3) - 2 s ring, 4 s pause
Default setting: 1000/4000 ms
Ringing signal DATA/FAX - cadence Function No.: 142
Data/Fax ringing signal cadency setting.
Setting options: 1000/4000 ms (0) - 1 s ring, 4 s pause
400/200/400/2000 ms (1)- 400ms ring, 200ms pause,
400ms ring, 2s pause
1500/3500 ms (2) - 1,5 s ring, 3,5 s pause
2000/4000 ms (3) - 2 s ring, 4 s pause
Default setting: 1000/4000 ms
CLI transmitting Function No.: 148
Set this item to enable/disable identification of a telephone line calling from a
GSM network. The function can be enabled if you have a device on your
telephone line that is capable of receiving FSK according to ETSI standards.
Setting options: Disable (0) - 2N® SmartGate does not transmit the
CLI.
FSK during ringing (1) -2N® SmartGate transmits the
FSK-based CLI according to the ETSI EN 300 659
standard (transmission during ringing).
Default setting: Disable