Google Outbound Services Configuration Guide - Manual (Page 108)

116 Outbound Services Configuration Guide
Links to IBM Lotus Domino Web sites are provided for your convenience. The
links and their content may change without notice. Please consult the product's
Web site for the latest configuration and support information.
Set Up Reinjection
Before you can register your IP addresses in the Administrative Console or set up
a smarthost, you must allow reinjection. For an overview of reinjection concepts,
see “Set Up Reinjection” on page 14.
Configure Outbound Services IP ranges to be a trusted relay
1. Open Domino Administrator and click Administration.
2. Select the Configuration tab.
3. Click the triangle next to Messaging, and then select Configurations.
4. Double-click the name of your Domino Server.
5. At the top of the window, click Edit Server Configuration. Select the following:
• Router/SMTP tab in the first row
• Restrictions and Controls tab in the second row
• SMTP Inbound Controls tab in the third row.
6. Under “Allow messages only from the following internet hosts to be sent to
external internet domains” enter the IP range for Outbound Services. For a list
of IP ranges, see “IP Ranges” on page 13.
7. Under “Exclude these Connecting Hosts From Anti-Relay Checks” enter the
same IP range.
8. Click “Save & Close” to exit.
9. Stop and restart the Domino SMTP task for the changes to take effect.
Register Your IP in the Administration Console
After you have set up reinjection, register the IP address of your outbound mail
server in the Administration Console. Do not change your smarthost until your IP
address is registered in Outbound Servers.
For instructions on how to register your IP in the Administration Console, see
“Register Your IP in the Administration Console” on page 15.