JLG X14J Operator Manual - Manual (Page 93)

keys group inside the electrical components compartment;
‑ Insert the key and open the distributor controls’ protection, if any,
to access the controls;
‑ Act on the distributor levers to enable the desired movement fol‑
lowing the instructions to be found on the label attached near the
controls and at the same time use the hand pump to power the
movement.
The sequence of movements is the following:
‑ retract extension arm
‑ fold jib arm
‑ fold first‑second arm
‑ At the end of the emergency operation, loosen the knob on the
proportional valve completely and remove it, reclose the protec‑
tion, if present, remove the key and put both the devices away in
their original positions.
I T IS PROHIBITED TO RELEASE THE AERIAL PART FROM THE REST POSITION WITH FUNCTIONING ENGI ‑
NE PROPORTIONAL VALVE .
T HIS OPERATION WOULD BE VERY RISKY FOR THE SAFETY OF THE OPERATOR ON THE PLATFORM
BASKET
.
X14JR0420113
BOOM LIFT MODELS X14J
JLG
89
D ISTRIBUTOR
PROTECTION
A DJUSTMENT
SCREW
O N ‑ OFF LEVERS / BUTTONS
PERICOLO
I
F THIS DEVICE HAS BEEN USED TO MOVE THE MACHINE
,
BEFORE USING THE MACHINE AGAIN TO
WORK AT A HEIGHT IT IS COMPULSORY TO SET IT IN THE TRANSPORT CONFIGURATION ( MACHINE
CLOSED AND ALIGNED
),
TO RAISE THE STABILISERS AND LOWER THEM AGAIN
.
ONLY THEN IT WILL BE
POSSIBLE TO WORK WITH THE MACHINE AT A HEIGHT CONTROLLING IT FROM THE BASKET .
PERICOLO
DANGER
DANGER