beautypg.com

JLG X14J Operator Manual User Manual

Page 80

background image

Note:

IT IS IMPORTANT TO REMIND THAT WHEN THE STABILISERS ARE LOWERED THE CARRIAGE

MUST

ALWAYS

BE RAISED FROM THE GROUND

.

After using the manual stabiliser control, remember to pressurise the bottom of the stabi‑
liser cylinders. To do this, run an auto‑stabilisation cycle or lower each stabiliser for one
second.

An electronic spirit level on the electronic control board checks that the machine is effectively
level within the allowable tolerance and enables the movements of the aerial part.

Incorrect machine stabilisation does not ensure suitable stability to perform operations. The
Constructor prohibits the use of the machine if it is not stabilised as described in this manual;
the machine overturning may cause serious injury to or even death of its occupants and per‑
sonnel on the ground.

If one of the orange lights positioned on each stabiliser should flash even when the stabi‑
liser is lifted from the ground, stop the machine immediately and call the after‑sales servi‑
ce as this signals the breakage of the corresponding stabiliser microswitch.

If working with the machine stabilised on slippery surfaces (marble, porphyry, polished
cement, smooth damp surfaces etc.) check that the movements of the basket do not cause the
tracks to move. If so, stop the operations and restore the safe operating conditions prescribed
by the manufacturer.

Make sure that the stabilisers rest on horizontal ground. DO NOT REST THE STABILI‑
SERS ON VERTICAL OR INCLINED SURFACES.

IMPORTANTE

ATTENZIONE

X14JR0420113

76

BOOM LIFT MODELS X14J

JLG

IMPORTANT

ATTENTION