JLG X14J Operator Manual - Manual (Page 74)

The electric motor can only be considered stopped if one of the emergency stop buttons
on the machine is pressed.
Whenever a movement of the machine has been completed and work needs to continue
with the machine off, one of the emergency stop buttons must be pressed and left activa‑
ted.
The machine must not be left off with the electronic board and the remote control powe‑
red.
6.4.6 A
UTOMATIC WORKING LOAD SELECTION
The JLG elevating platform can work with two different loads: 200 kg or 120 kg. According
to the working load selected, one of the two work areas available on the machine will be ena‑
bled.
The working load depends on the position of the jib arm. If this is completely folded the
allowable working load is 200 kg and this is indicated by an icon in position 2 on the remote
control; if the jib is not completely folded the allowable working load is 120 kg and this is
indicated in position 2 on the remote control. If the operator attempts to open the jib with
more than 120 kg in the basket an error message appears in the middle of the display.
If the allowable load limits are exceeded all aerial movements are disabled, an alarm messa‑
ge appears on the remote control and the buzzer sounds. To restore operation, the excess
load needs to be removed.
X14JR0420113 70
BOOM LIFT MODELS X14J
JLG