JLG X14J Operator Manual - Manual (Page 78)

The complete closure and alignment is displayed by the arrows on the machine (SEE
PHOTO) and the display of the icon in position 6 on the radio control.
‑ The stabilisers can be lowered from the control position in the basket or on the ground.
If controlled from the ground make sure that visibility of the trajectory of each stabiliser
is perfect before moving it and verify the distance between the ground and check that at
the end of the stabilisation phase the distance between the ground and the lower limit of
the basket access ladder is less than 40cm. If this is not the case, approach the ladder to
the ground and carry out the basket stabilisation procedure.
‑ Select the engine revs. as required.
Always perform stabilisation at slow speed.
‑ Press and hold the automatic stabilisation button 7 (see the corresponding paragraph). If
the movements are selected with the machine not completely closed and aligned, an
error message will be shown on the display.
X14JR0420113 74
BOOM LIFT MODELS X14J
JLG