JLG X14J Operator Manual - Manual (Page 60)

Considering the hazard deriving from the use of the platform during the bypass of the
safety devices, carefully read the paragraphs regarding the use of the safety device release
key selector switch
The key used to activate the safety device bypass is lead‑sealed on the side of the electrical
components compartment near the battery.
Force the lead‑sealing to remove it. After using the safety device bypass a JLG after‑sales
centre must be contacted in order to verify the causes that determined the need to use the
safety device bypass and to lead‑seal the key.
The safety device electronic control board records every time the safety device bypass key
is activated along with the movements made during these operations.
The safety device bypass system is used to move the machine with a higher load than the
limit load allowed inside the basket; the overload alarm is nonetheless displayed and the
beeper warns the operator of the dangerous conditions. This device must only be used by
expert personnel trained on how to use the machine, while the end user, who does not
fully know the machine’s operating principles, is not allowed to use this device.
5.5 E MERGENCY POSITION CONTROLS
‑ SELECTION PANEL, EMERGENCY STOP AND START.
The following are housed on the panel:
‑
Three position key for the selection of control location/panel.
1_The key in central (neutral) position validates the remote primary control in the
basket.
2_Turning the key clockwise and keeping it in place the emergency control position is
enabled. If you want the arms to start moving, the main proportional valve of the
hydraulic system has to be energized. On the Lithium version, it also starts the electric
PERICOLO
X14JR0420113 56
BOOM LIFT MODELS X14J
JLG
DANGER
E
NGINE
START
E
LECTRIC
MOTOR START
AERIAL PART
MOVEMENTS
ENABLED LIGHT
AERIAL PART
MOVEMENTS
ENABLED
LIGHT
THERMIC MOTOR LITHIUM MOTOR