IKA C 5000 control Package 2/12 - Manual (Page 66)

6\VWHP FDOLEUDWLRQ
IKA  -WERKE C 5000 control/duo-control Ver. 10 04.07
3DJH
d
Activate 6WDUW . The measurement cell cover closes.
Each time 1000 ignitions have been performed using a given decomposition vessel,
the following message will appear:
1000 ignitions performed with Bomb x
Inspect decomposition vessel
or contact IKA service
This indicates that the decomposition vessel has reached a maintenance point and
that a safety check must be carried out. Confirm this message by pressing 7$%
and 2. in sequence.
This message does not release the user from the responsibility of also continuously
checking the decomposition vessel for wear and carrying out safety inspections as
required.
The decomposition vessel is then filled with oxygen. Next, the inner vessel is filled
with water. As soon as the system begins with the experiment, the display shows a
graph of the change over time in the temperature of the inner vessel.
R2§©¨9¡©&3%¥ 44¥ §'%
© #"3 2(%1¤3 9¡©%4¥ §¤§3
&($$)(£¦1¤3¥ §©¨429(2) ¥ 8¤3 2 %¥ ¡¦§
e
If necessary:
You can interrupt the experiment at any time with &DQFHO . For the process, see item
5.
f
For systems ZLWK WZR PHDVXUHPHQW FHOOV
You can now perform steps 1 - 9 from Section 9.1 and steps 1 - 3, from the same
section with the second measurement cell.
g
When the measurement is complete, the measurement cell cover opens and pres-
sure is released from the decomposition vessel. At the same time, the inner vessel
is emptied. After that, the cover opens up completely. As soon as the message
%RPE Ï appears in the bottom line, you can remove the decomposition vessel.