IKA C 5000 control Package 2/12 - Manual (Page 56)

6HWWLQJ XS DQG SODFLQJ LQ VHUYLFH
IKA  -WERKE C 5000 control/duo-control Ver. 10 04.07
3DJH
/DVW H[SHULP The system accepts the 8VHU and 6DPSOH SURSHUWLHV
parameters for a new experiment as well as the indi-
cated post-experiment parameters of the last experi-
ment to be evaluated.
If the 8VHU GHI QDPH option has been selected, the
sample name is also accepted. This must then be ed-
ited or reentered to make up for the difference.
6WDQGDUG The post-experiment parameters are set to 0 for a new
experiment. The extraneous energy is set to 50 J/0 J
(without/with combustible crucible), and the 8VHU and
6DPSOH SURSHUWLHV boxes in the 6DPSOH dialog box re-
main empty.
8QLW configuration box
The unit of measure for the caloric results is specified here. This refers only
to the result protocols! Available for selection:
-RXOHVJ
FDOJ
%78OLE
N:+NJ
( ) 0-NJ
(YDOXDWLRQ configuration box
( ) ',1,.$ The calculation modes used previously for IKA 
calorimeters are grouped under this evaluation
procedure.
( ) $670 ' ' ' ' ' (
This procedure takes into account current US
standards for combustion calorimetry of solid and
liquid fuels, and wastes.
The evaluation procedure selected will be used for all subsequent evalua-
tions. Measurements already evaluated will not be affected by a change un-
less they are re-evaluated. In such a case, all the evaluation parameters al-
ready entered will be reset to zero.
When you click on 2. the calorimeter system accepts the settings and closes the
dialog box.