Brother HE-800A - Manual (Page 116)

HE-800A
16. TROUBLESHOOTING
108
Cause Check Remedy Page
Upper thread
scissors Upper thread scissors
operation Adjust the upper thread scissors to the standard
setting.
76
Work clamp home
position sensor Work clamp home
position sensor position Adjust the work clamp home position sensor
position.
-
ውዒ-ዎዑ. Lower thread is not trimmed (pulls when material is removed)
Cause Check Remedy Page
Machine stopping
position Rotary hook touches
lower thread retainer at
the stop position Adjust the needle up stop position.
77
Fixed knife and movable
knife do not mesh. Adjust the fixed knife set installation position.
-
Fixed knife set
Knife tip is bent or
chipped. Repair or replace the knife.
-
ውዒ-ዎዒ. Feed mechanism does not operate or motor is out of step
Cause Check Remedy Page
Feed pulse motor Cord connection Check the cord connections and contacts. -
Upper thread scissors
position Remove and re-install the upper thread scissors.
-
Upper thread
scissors
Check if the cam opens
the stop plate.
Adjust the cam position.
* If the feed mechanism operates when the cam has
not opened the stop plate, the cutter will bump
against the upper thread scissors.
76
4021Q
Retainer
Inner rotary
hook presser
4024Q
Fixed knife
Movable knife
4108M
Projection on scissors M is inserted.
* Always make sure that the upper
thread scissors are in the correct
position before use.
4018Q