ውዒ - ውዕ . cutter does not return, ውዒ - ዎዌ . cutter and upper thread scissors touch, ውዒ - ዎው . seam is cut – Brother HE-800A User Manual
Page 113

HE-800A
16. TROUBLESHOOTING
105
Cause Check
Remedy
Page
Nut
Check if the nut is loose, and tighten it securely.
-
Solenoid stopper
Cutter sensor position
Adjust the cutter sensor position.
Check if the mounting screws are loose, and
tighten them securely.
-
Cutter bar guide
Smoothness
of
cutter
operation
Adjust the cutter bar guide so that the cutter
operates smoothly with no play.
-
ውዒ-ውዕ. Cutter does not return
Cause Check
Remedy
Page
Cutter
Cutter blade
If blade is worn or chipped, sharpen it or replace it.
-
Sticks in material
Needle plate
Replace with the special needle plate (optional).
4
Cutter bar guide
Smoothness
of
cutter
operation
Adjust the cutter bar guide so that the cutter
operates smoothly with no play.
-
ውዒ-ዎዌ. Cutter and upper thread scissors touch
Cause Check
Remedy
Page
Upper thread
scissors
Check if the cam opens
the stop plate.
Adjust the cam position.
* If the feed mechanism operates when the cam has
not opened the stop plate, the cutter will bump
against the upper thread
scissors
.
76
ውዒ-ዎው. Seam is cut
Cause Check
Remedy
Page
Length of knife
setting
Length of knife
Set parameter number 02 to the same value as the
length of the knife being used.
36
Knife space setting
Cutting of zigzag seam
Use parameter number 06 to set the knife X
space.
Use parameter number 08 to set the knife X
position alignment.
36, 37
Cutter play
Adjust the cutter bar guide so that the cutter
operates smoothly with no play.
-
Cutter
Cutter knife bending
Use the cutter holder (option) to prevent the cutter
knife from becoming bent.
-
Cutter sensor
4017Q
4018Q
4.5
r 0.5 mm
4019Q