beautypg.com

Apple Xserve (Early 2008) DIY Procedure for Enclosure User Manual

Page 58

background image

Xserve (Early 2008) Locking Mechanism Rod and Gear Replacement Instructions

4

Installing the Replacement Locking Mechanism Rod and Gear

To install a replacement locking mechanism gear, slide it onto the notched end of the

1.

locking rod by aligning the narrow end of the gear with the end of the rod.

Note: Make sure the rib inside the gear engages with the notch in the rod.

To install a replacement locking mechanism rod, insert the end of the rod with the key hole

2.

into the port on the front bezel.

Note: Make sure the small circle on the front of the rod aligns with the “unlocked” symbol on
the front of the bezel.

Pull back the latch that secures the rod, and gently press the rod down until it clicks into

3.

place.

See also other documents in the category Apple Software: