beautypg.com

Installing the replacement fan array – Apple Xserve (Early 2008) DIY Procedure for Enclosure User Manual

Page 30

background image

Xserve (Late 2006/Early 2008) Fan Array Replacement Instructions

5

Installing the Replacement Fan Array

Install the foam included in the replacement parts box on the replacement fan array, as

1.

shown below.

Align the power connector on the fan array with its connector on the power distribution

2.

board and lower the array into the enclosure. Push down on the fan array power connector
to make sure it is fully seated.

Tighten the screws at the ends of the array. Make sure the large front panel board cable runs

3.

above the power connector but below the tab on the top of the power supply.

See also other documents in the category Apple Software: