beautypg.com

Apple Xserve (Early 2008) DIY Procedure for Enclosure User Manual

Page 166

background image

Xserve (Late 2006/Early 2008) Rear ID Tab Replacement Instructions

25

Connect the cable to the logic board first. Then press the adhesive section of the cable onto

2.

the enclosure before connecting the other end of the cable to the backplane.

Caution: Make sure the cable is fully seated.

Replacing the Fan Array

Align the power connector on the fan array with its connector on the power distribution

1.

board and lower the array into the enclosure. Push down on the fan array power connector
to make sure it is fully seated.

Tighten the screws at the ends of the array. Make sure the large front panel board cable runs

2.

above the power connector but below the tab on the top of the power supply.

See also other documents in the category Apple Software: