beautypg.com

AEM 30-1913 Universal Fuel Ignition Controller 6 Channel User Manual

Page 29

background image

Page 29

PC Logging:

The F/IC software allows you to log data to your PC while connected to the F/IC.

The sampling rate and file size are determined by the available memory and processor
speed of the PC. To start PC logging, go to Logger>PC Logger Start. To stop PC
logging go to Logger> PC Logger Stop, give the file a name and save it. Logged files
are saved as delimited text files.

Dual Calibration:

The F/IC has a

“Dual Calibration” mode, which allows the user to switch between

two maps with the flip of a switch. Some common uses for this are a race gas map, a
pump gas map, or a valet mode map. The

“User Switch Input” is used to switch

between maps. In order to use the

“Dual Calibration” feature of the F/IC, the “Dual

Calibration

” mode must be selected in the “Setup” window, see Figure 35. When the

“User Switch Input” wire is not connected to ground, the F/IC uses calibration “A”.
When the user input switch wire is connected to ground, the F/IC uses calib

ration “B”.

To upload/edit Calibration A, verify the user input wire is not connected to ground, the
follow the instructions

in the “Connecting to FIC” section. To upload/ edit Calibration B,

verify the

“User Switch Input” wire is connected to ground, the follow the instructions in

t

he “Connecting to FIC” section. (Note: The F/IC will disconnect from the PC if you try to

switch calibrations while connected.)