AEM 30-1913 Universal Fuel Ignition Controller 6 Channel - Manual (Page 25)

Page 25
MAF:
Select the load input and operating mode for the MAF map. Set the
maximum voltage clamp (max output voltage) for the MAF map.
Analog A(B):
Select the load input and operating mode for the Analog A(B) map.
O2:
Select the load input and operating mode for the O2 map. Set the period
for the fixed and percentage modes. Set the high and low voltages for bank 1
and bank 2. Set the Start Delay time, which is the amount of time in seconds that
the F/IC waits for the O2 outputs to be functional after the F/IC is turned on.
Select the High Level Drive option (This option allows for better AFR resolution
on certain vehicles with UEGO style oxygen sensors). Select the view as AFR
option.
F/IC Logger:
Set the on conditions and sample rate for the F/IC internal logger. Note:
The on conditions must be met and the logger trigger input must be grounded
before the internal logger will begin logging.
Switched 12V
DC
:
Set the on/off conditions for the Switched 12 V
DC
output wire.
Connecting to the F/IC:
(Note: when connecting to the F/IC for the first time, the found new hardware
window will appear. The USB drivers will load automatically.)
Connect the F/IC to the PC using the supplied USB cable. With a calibration already
open, click on the connect button to connect to the F/IC. See Figure 36.
Figure 38: Connect icon
(Note: If the opened file does not match the file in the F/IC, a window will appear, asking
if you want to copy the PC file to the F/IC or if you want to copy the F/IC file to the PC.
Follow the on-screen instructions to proceed. See Figure 39.)