J.P. Instruments EDM 930 Primary Primary Installation Manual User Manual
Page 33
FAA Approved Installation Manual for the
Report No 908
EDM-900 and EDM-930
Page 33 of 50 Rev J
Primary Engine Data Management System Date 5-24-2014
2 Ring Terminals
2 Screws and Nuts 6-32 X1/4"
1 Fiberglass tube 3/8” x 5”
29.6
Component Parts list for OIL Temperature probe (KIT 1250)
1 P/N 400509 OIL probe
1 AN900-10 crush washer
2 Ring Terminals
2 Screws and Nuts 6-32 X 1/4"
1 Fiberglass tube 3/8” x 5”
29.7
Component Parts list for Oil Pressure sensor KIT 1460
1 P/N 159936A Oil Pressure sensor
1 P/N 159961 Clamp, Loop Cushioned
1 P/N 174402 Connector Pack 3 Pin and Terminals
29.8
Component Parts list for Kit 1480 Differential Fuel Pressure (only if required by POH)
1 P/N 159938 Fuel pressure sensor
1 P/N 159961 Clamp, Loop Cushioned
1 P/N 174204 Connector MS 3116F8-4S
29.9
Component Parts list for ampere shunt Kit 1300
1 P/N 159920 100 amp shunt
2 Ring Terminals
29.10
Component Parts list for Fuel Flow Transducer
1 fuel flow transducer, 201 or 231 PN 700900-1,-2
8 inches of 1.5” dia. fire sleeve
1 3-pin connector housing
3 female pins
2 AN816-4-4 fittings (Continental) or AN816-4-6 (Lycoming)
29.11
Component Parts list for MAP sensor KIT 1440
1 P/N 159934A Manifold pressure sensor
1 P/N 159961 Clamp, Loop Cushioned
1 P/N 174402 Connector Pack 3 Pin and Terminals
29.12
Components Parts list for non pressurized RPM sensor P/N depends on Magneto make and model
Bendix magneto -20,1200………….P/N 420815-2
Slick magneto 4000 or 6000………P/N 420815-1
Bendix dual ………………………….P/N 420808