J.P. Instruments EDM 930 Primary Primary Installation Manual User Manual
Page 10
FAA Approved Installation Manual for the
Report No 908
EDM-900 and EDM-930
Page 10 of 50 Rev J
Primary Engine Data Management System Date 5-24-14
5. EDM Display Installation
Choose the Proper Installation Location
The display is best located within the natural scan and easy reach of the pilot. The recommended mounting location
is defined as the distance from the vertical centerline of the Primary Flight Instruments to the outer edge of the
further most gauge displayed on the EDM.
HORIZONTAL ORIENTATION:
The EDM display may be mounted from the vertical centerline of the Primary Flight Instrument “T” to a maximum of
21” to the further most gauge of the EDM display and to the left of the centerline as much as needed.
VERTICAL ORIENTATION:
The EDM display is to be mounted within +/- 10” from the horizontal centerline of the Primary Flight
Instrument “T”. The installer should insure that the EDM display is not obstructed by either
the glare shield or the control wheel.
The installing A&P and IA must insure that the installation location complies with the viewing angle requirements
listed above.
8. EDM-900/930 Key information installation
Aircraft specific configuration information is loaded differently on both the EDM-900 and the EDM-930. The
configuration data is the same for both instruments. The data for the EDM-900/930 is loaded via the mini USB port
on the EDM-900 and a standard USB port for the EDM-930.