J.P. Instruments EDM 930 Primary Primary Installation Manual - Manual (Page 24)

FAA Approved Installation Manual for the Report No 908
EDM-900 and EDM-930 Page 24 of 50 Rev J
Primary Engine Data Management System Date 5-24-14
22.4.1 After you have collected your data
After you have collected your data…Entering / Editing Fuel Level Calibration Data
The Fuel Table Editor is a spreadsheet type format allowing you to easily see the volume and related calibration
values side by side. You can easily navigate through the cells to enter values.
1. With power off, hold in Button 3 (Button 1 being far left) and then turn on power. Wait until you see ‘Do
you agree with the disclaimer?’. Tap YES if you agree and wish to continue.
2. Tap YES when you see ‘Do you have table data?’.