SkyTrak 6042 Operation Manual - Manual (Page 54)

52 Model 6042 Origin 5/02
Operation
Cab Heater & Fan Control
(Figure 34)
The cab heater controls (Figure 34, 1) are located directly below the switch
banks on the right side dash panel. The control panel consists of: a variable
speed fan control knob (2) and a temperature control knob (3).
Control of air flow to the windshield is made by opening, closing or
redirecting the air vent louver on the front dash. The cab is heated by the
heater unit positioned under the operators seat.
To heat the cab:
• Turn temperature control knob (Figure 34, 3) to far right position
(RED = HOT),
• Direct desired air flow by adjusting vent louvers under the seat,
• Turn fan control (Figure 34, 2) to “3” to assure rapid warm-up.
To defrost the cab:
• Turn temperature control knob (Figure 34, 3) to the far right
position (RED = HOT),
• Direct desired air flow by adjusting vent louver on the front dash,
• Turn fan control (Figure 34, 2) to “3” to assure rapid defrost.
Figure 34
OS1950
OS1950
OA1390
3
OH1883
2
1