Figure 93, General maintenance – SkyTrak 6042 Operation Manual User Manual

Page 144

142

Model 6042

Origin 5/02

General Maintenance

5. Pressurize the parking brake with the pressurizing unit. Close the

needle valve on the pressurizing unit.

6. Working through the level plug hole (Figure 93, 1), carefully use a

screwdriver to spread the brake disks apart.

IMPORTANT! DO NOT damage the surfaces of the brake disks when
spreading the brake disks.

Figure 93

7. Using a feeler gauge, check the gap (Figure 94, 1) between the

brake disks (2). If the gap is greater than .167" (4,25 mm), replace
the brake disks.

NOTE: If the brake disks are worn beyond .167" (4,25 mm), the brake disk
must be replaced on both sides of the axle at the same time.

8. Repeat step 6 and step 7 for the other side of the axle.

MT2850