SkyTrak 6042 Operation Manual - Manual (Page 132)

130 Model 6042 Origin 5/02
General Maintenance
A. Engine Fan Belt Check
(1000 Hour Intervals)
1. Ground the carriage,
place the travel select
lever in (N) NEUTRAL, move the neutral lock lever to NEUTRAL
LOCK position, engage the parking brake switch and shut off the
engine.
2. Unlock and open the left rear engine access door.
3. Inspect the fan belt (Figure 83, 1). Replace if cracked or frayed.
4. This engine is equipped with an automatic belt tensioner (Figure
83, 2). Inspect the tensioner bearing. Spin the bearing and check
for rough spots under hand pressure.
5. Spin the fan and check for wobble or excessive play. Maximum play
should be .006 inch (0,15 mm).
6. To install the fan belt (Figure 83, 1); first position the belt over the
fan pulley (3), crankshaft pulley (4), alternator pulley (5) and then,
while holding up the tensioner (2), slide the belt over the water
pump pulley (6).
7. Close and lock the left rear engine access door.
Figure 83
6. Engine Fan Belt
1000
OS08802 OH2690
OT04002
3
4
6
5
2
1